Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection
- CHECK TRANSMISSION RANGE SWITCH-1
- Turn ignition switch ON.
- Check the voltage between ECM harness connector and ground.
ECM
Condition
Voltage
+
-
connector
Terminal
connector
Terminal
F24
15
E16
162
Selector lever
P or N
12 V
Other than above
0 V
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO 2.
- CHECK TRANSMISSION RANGE SWITCH-2
- Remove transmission range switch. Refer to Exploded View .
- Check transmission range switch. Refer to Inspection .
Is the inspection result normal?
YES
INSPECTION END
NO
Replace transmission range switch. Refer to Exploded View .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.