Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnosis Procedure
- CHECK DTC
- Check that DTC UXXXX is not displayed.
Is the inspection result normal?
YES
GO TO 2.
NO
Perform trouble diagnosis for DTC UXXXX. Refer to DTC Index .
- CHECK DTC WITH COMBINATION METER
Check DTC with combination meter. Refer to Work Procedure (TYPE A), Work Procedure (TYPE B).
Is the inspection result normal?
YES
GO TO 3.
NO
Perform trouble diagnosis for DTC indicated.
- CHECK INTERMITTENT INCIDENT
Check intermittent incident. Refer to Intermittent Incident .
Is the inspection result normal?
YES
Replace combination meter. Refer to Removal and Installation (Type A), Removal and Installation (Type B).
NO
Repair or replace error-detected parts.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
