Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection
- CHECK ASCD STEERING SWITCH
- Turn ignition switch OFF.
- Disconnect combination switch (spiral cable) harness connector.
- Check the resistance between combination switch harness connector terminals as per the following conditions.
Combination switch
(Spiral cable)
Condition
Resistance
(Approx.)
Connector
+
-
Terminal
M96
21
36
MAIN switch: Pressed
0 Ohms
CANCEL switch: Pressed
250 Ohms
SET - switch: Pressed
660 Ohms
RES + switch: Pressed
1, 480 Ohms
All ASCD steering switches: Released
4, 000 Ohms
Is the inspection result normal?
YES
INSPECTION END
NO
Replace ASCD steering switch. Refer to Removal and Installation .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.