Work Procedure

There is no vehicle specification in the new IPDM E/R, so the vehicle specification needs to be written in IPDM E/R with CONSULT.

Configuration has three functions as follows.

Function		Description
Before ECU Replacement		Reads the vehicle configuration of current IPDM E/R Saves the read vehicle configuration
After ECU Replacement	FAST linked	NOTE: This item is displayed, but cannot be used
	Manual selection	Writes the vehicle configuration with manual selection.

1. WRITING MODE SELECTION 

   CONSULT

   Reads the vehicle specification.

   When writing saved data (able to be read)

   GO TO 2.

   When writing manually (could not be read)

   GO TO  3.

2. PERFORM WRITING SAVED DATA 

   CONSULT

   1. Ignition switch ON.
   2. Select "Re/programming, Configuration". Select the vehicle specifications saved with "Before ECU Replacement" and then write them to the replacement IPDM E/R.

   GO TO  5.

3. PERFORM WRITING MANUALLY (IPDM E/R) 

   CONSULT

   1. Ignition switch ON.
   2. Select the "IPDM E/R" of "Re/programming, Configuration".
   3. Select the "Type ID" searched by using FAST (service parts catalogue) to write the "Type ID" into the IPDM E/R.
      CAUTION: Check the "Type ID" accurately. If the "Type ID" is selected incorrectly, ECU control may not function normally.

   GO TO 4.

4. PERFORM WRITING MANUALLY (HLL) 

   CONSULT

   Select the "HLL" tab. Select the specifications applicable to the vehicle and then write them to IPDM E/R. Refer to Work Item List .

   CAUTION:

   • Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct.
   • If the operation ends in mid operation, it is because vehicle specifications are not saved. Be sure to complete writing, even if the settings values displayed in "Manual selection" and the settings values in the ECU settings list are the same.

   GO TO 5.

5. OPERATION CHECK 

   Confirm that each function controlled by IPDM E/R operates normally.

   Work Item.