2020 Nissan-Datsun NV200 SVFACTORY OEM SERVICE PROCEDURE

Work Procedure

  1. STEP 1Β 
    1. Disconnect battery negative terminal or power main switch connector. Reconnect it after a minute or more.
    2. Turn ignition switch ON.
    3. Operate the power window switch to fully open the window. (This operation is not necessary if the window is already fully open).
    4. Continue pulling the power window switch UP (AUTO-UP operation). Even after the glass stops at fully closed position, keep pulling the switch for 3 seconds or more.
    5. Retest the AUTO-UP function operation.

    GO TO 2.

  2. STEP 2Β 

    Check anti-pinch function. Refer to Work ProcedureΒ .

    Inspection End.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.