NOTE: This procedure is for the Vehicle Information Display (inside tachometer, lower right).

Maintenance intervals shown in the Vehicle Information Display are reset using the Drive Computer buttons. See Fig 1.

With the ignition switch in the ON position, push the ENTER button (1) repeatedly until the SETTING menu is displayed. See Fig 1.
Use the NEXT button (2) to select MAINTENANCE menu, then confirm with the ENTER (1) button. Select item to adjust or reset:
- OIL > ENGINE OIL
- FILTER
- OIL > T/M OIL (Transmission Fluid)
- TIRE
Input the maintenance reminder adjustments by doing the following:
- To reset the automatic reminder mileage to zero, go to the RESET menu, then push the NEXT button and confirm with the ENTER button.
- To adjust the mileage until next reminder, on each setting menu, push the NEXT button. Push and hold the button to increase the number every 600 miles (1, 000 km).
- To change to No Reminders, set to "-".
To return to the initial SETTING menu, press and hold the ENTER button for at least 1 second.

Fig 1: Identifying Drive Computer Display & Buttons

Courtesy of NISSAN MOTOR CO., U.S.A.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Maintenance Service Reminder Reset - Procedure 09