Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Nissan-Datsun Sentra SLFACTORY OEM SERVICE PROCEDURE
Work Procedure
WARNING: This page is about a different variant/trim than selected.
- PREPARATION BEFORE CALIBRATION PROCEDURE
- Park the vehicle on a level surface.
- Adjust air pressure of all tires to the specified pressure. Tire Air Pressure .
GO TO 2 .
- PERFORM CALIBRATION
With CONSULT
- Turn ignition switch ON.CAUTION: Never start engine.
- Select "Work Support" mode in "ENGINE".
- Select "G SENSOR CALIBRATION".
- Touch "Start".CAUTION: Never swing the vehicle during "G sensor calibration".
Is "COMPLETED" displayed?
YES
END
NO
Perform steps 1 and 2 again.
- Turn ignition switch ON.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
