Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Nissan-Datsun Sentra SLFACTORY OEM SERVICE PROCEDURE
Brake Control System (Introduction And Basic Inspection) (With ICC)
- With ICC
- Precaution
- Preparation
- System Description
- Component Parts
- Component Parts Location
- Wheel Sensor and Sensor Rotor
- ABS Actuator and Electric Unit (Control Unit)
- Stop Lamp Switch
- Steering Angle Sensor
- Brake Fluid Level Switch
- Parking Brake Switch
- VDC OFF Switch
- ADAS Control Unit
- Distance Sensor (ICC Sensor)
- Brake Pedal Position Switch / Stop Lamp Switch
- ICC Brake Hold Relay
- System
- Diagnosis System [Abs Actuator And Electric Unit (Control Unit)]
- Diagnosis System [Distance Sensor (ICC Sensor)]
- Component Parts
- Ecu Diagnosis Information
- Wiring Diagram
- Basic Inspection
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.