2018 Nissan-Datsun Versa Note SRFACTORY OEM SERVICE PROCEDURE

Work Procedure

  1. SAVING VEHICLE SPECIFICATION 

    SYMBOL CONSULT Configuration

    Perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to Description .

    NOTE: If "READ CONFIGURATION" can not be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.

    GO TO 2 .

  2. REPLACE BCM 

    Replace BCM. Refer to Removal and Installation .

    GO TO 3 .

  3. WRITING VEHICLE SPECIFICATION 

    SYMBOL CONSULT Configuration

    Perform "WRITE CONFIGURATION - Config file" or "WRITE CONFIGURATION - Manual selection" to write vehicle specification. Refer to Work Procedure .

    GO TO 4 .

  4. REGISTER INTELLIGENT KEYS 

    For initialization and registration of Intelligent Keys, refer to CONSULT immobilizer mode and follow the on-screen instructions.

    WORK END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.