Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Nissan-Datsun Versa Note SFACTORY OEM SERVICE PROCEDURE
Work Procedure
- PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION KEY IDS
Perform BCM initialization. (NATS)
GO TO 2 .
- PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNING
Refer to Work Procedure .
GO TO 3 .
- PERFORM THROTTLE VALVE CLOSED POSITION LEARNING
Refer to Work Procedure .
GO TO 4 .
- PERFORM IDLE AIR VOLUME LEARNING
Refer to Work Procedure .
END
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
