2018 Nissan-Datsun Versa Note SFACTORY OEM SERVICE PROCEDURE

Work Procedure

  1. SAVING VEHICLE SPECIFICATION 

    SYMBOL CONSULT Configuration

    Perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to Description .

    NOTE: If "READ CONFIGURATION" can not be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.

    GO TO 2 .

  2. REPLACE BCM 

    Replace BCM. Refer to Removal and Installation .

    GO TO 3 .

  3. WRITING VEHICLE SPECIFICATION 

    SYMBOL CONSULT Configuration

    Perform "WRITE CONFIGURATION - Config file" or "WRITE CONFIGURATION - Manual selection" to write vehicle specification. Refer to Work Procedure .

    GO TO 4 .

  4. REGISTER INTELLIGENT KEYS 

    For initialization and registration of Intelligent Keys, refer to CONSULT immobilizer mode and follow the on-screen instructions.

    WORK END

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.