2017 Nissan-Datsun Versa Note SLFACTORY OEM SERVICE PROCEDURE

Removal And Installation: Removal

  1. Perform a CPU memory erase on the EPS with CONSULT before removal.
  2. Disconnect the battery cable from the negative terminal. Refer to REMOVAL AND INSTALLATION (BATTERY) .
  3. Remove instrument lower panel (LH). Refer to REMOVAL AND INSTALLATION .
  4. Disconnect harness connectors from EPS control unit.
    CAUTION:

    Hold and pull the connector housing, do not pull on harness when disconnecting connectors. Also, do not grip, collapse or apply excessive force to the connector.

  5. Remove screws and EPS control unit from steering column.
  6. Remove bolts and bracket plate from steering column (if necessary).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.