2017 Nissan-Datsun Versa Note SLFACTORY OEM SERVICE PROCEDURE

Service Notice Or Precautions For Steering System: Notes

  • In case of removing the steering gear, make the final tightening with grounded and unloaded vehicle condition, and then check wheel alignment.
  • Observe the following precautions when disassembling.
    • Before disassembly, thoroughly clean the outside of the unit.
    • Disassembly should be done in a clean work area. It is important to prevent the internal parts from becoming contaminated by dirt or other foreign matter.
    • For easier and proper assembly, place disassembled parts in order on a parts rack.
    • Use nylon cloth or paper towels to clean the parts; common shop rags can leave lint that might interfere with their operation.
    • Do not reuse non-reusable parts.
    • Before assembling, apply the specified grease to the directed parts.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.