Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Nissan-Datsun Sentra SRFACTORY OEM SERVICE PROCEDURE
Input/Output Signal Chart
WARNING: This page is about a different variant/trim than selected.
INPUT
| Unit/Sensor | Input signal to ECM | ECM function |
|---|---|---|
| EVAP control system pressure sensor | Pressure in purge line | Fuel filler cap warning control |
| Combination meter | Fuel level | |
| Fuel filler cap warning reset signal* |
* : This signal is sent to the ECM via the CAN communication line.
OUTPUT
| Unit | Output signal | Actuator |
|---|---|---|
| ECM | Fuel filler cap warning display signal* | Combination meter |
* : This signal is sent to the combination meter via the CAN communication line.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
