2017 Nissan-Datsun Sentra SLFACTORY OEM SERVICE PROCEDURE

Component Description

Component part Description
Starter motor The starter motor plunger closes and the motor is supplied with battery power, which in turn cranks the engine, when the S terminal is supplied with electric power.
Transmission range switch (CVT Models) Transmission range switch supplies power to the starter relay and starter control relay inside the IPDM E/R when the shift selector is placed in the P or N position.
IPDM E/R CPU inside IPDM E/R operates the starter control relay when the ignition switch is in the start position.
Clutch interlock switch (M/T Models) Clutch interlock switch supplies power to the coil side of the starter
relay and starter control relay (inside IPDM E/R) when the clutch pedal is depressed to crank the engine.
ECM ECM controls the starter control relay inside the IPDM E/R.
BCM BCM controls the starter relay inside IPDM E/R.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.