Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Nissan-Datsun Maxima SLFACTORY OEM SERVICE PROCEDURE
DTC Index
| DTC | Items (CONSULT screen terms) | Reference |
|---|---|---|
| C1143 | ST ANG SEN CIRCUIT | DTC LOGIC |
| C1601 | BATTERY VOLT | DTC LOGIC |
| C1602 | NO TUNING SET | DTC LOGIC |
| C1606 | EPS MOTOR | DTC LOGIC |
| C1607 | EEPROM | DTC LOGIC |
| C1608 | CONTROL UNIT | DTC LOGIC |
| C1609 | CAN VHCL SPEED | DTC LOGIC |
| C160A | HEAT PROTECTION | DTC LOGIC |
| U1000 | CAN COMM CIRCUIT | DTC LOGIC |
NOTE:
If two or more DTCs are detected, refer to DTC INSPECTION PRIORITY CHARTΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
