Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Nissan-Datsun Maxima SLFACTORY OEM SERVICE PROCEDURE
Component Location: Body
| Center stack | Steering column area | Pedal periphery | |||
| Inside fuel tank | Rear of fuel tank area |
| No. | Component | Function |
|---|---|---|
| AC auto amp | Mainly transmits the following signal to ECM via CAN communication.
Refer to COMPONENT LOCATION for detailed installation location. |
|
| Combination meter | Mainly transmits the following signal to ECM via CAN communication.
Mainly receives the following signal from ECM via CAN communication.
Refer to COMPONENT LOCATION for detailed installation location. |
|
| ASCD steering switch | ASCD STEERING SWITCH | |
| Stop lamp switch | STOP LAMP SWITCH & BRAKE PEDAL POSITION SWITCH | |
| Brake pedal position switch | STOP LAMP SWITCH & BRAKE PEDAL POSITION SWITCH | |
| Accelerator pedal position sensor | ACCELERATOR PEDAL POSITION SENSOR | |
| Fuel level sensor unit and fuel pump (with fuel tank temperature sensor) | FUEL LEVEL SENSOR UNIT AND FUEL PUMP (WITH FUEL TANK TEMPERATURE SENSOR) Refer to EXPLODED VIEW WITH TORQUE SPECIFICATIONS for detailed installation location. |
|
| Fuel tank temperature sensor | ||
| EVAP control system pressure sensor | EVAP CONTROL SYSTEM PRESSURE SENSOR | |
| EVAP canister vent control valve | EVAP CANISTER VENT CONTROL VALVE | |
| EVAP canister | EVAP CANISTER |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
