2017 Nissan-Datsun Maxima SLFACTORY OEM SERVICE PROCEDURE

Component Location

GNSALMIA0836ZZ-836Courtesy of NISSAN NORTH AMERICA, INC.
A. Front of center console B. Behind front of center console (view with center console finisher removed)
C. Instrument lower panel LH Β  Β 
No. Component Function
1. CVT shift selector CVT shift selector detects shift lever status, transmits detention switch signal to BCM.
Refer to COMPONENT LOCATION for detailed installation location.
2. Stop lamp relay Refer to COMPONENT LOCATION (LED headlamp) or COMPONENT LOCATION (halogen headlamp).
3. IPDM E/R
  • IPDM E/R detects push-button ignition switch (push switch) status, and transmits push-button ignition switch status signal (CAN) to BCM.
  • IPDM E/R receives ignition relay (IPDM E/R) control signal and ignition switch ON signal (CAN) from BCM, and controls ignition relay (built in IPDM E/R)
Refer to COMPONENT LOCATION for detailed installation location.
4. BCM
  • BCM controls power distribution system.
  • BCM judges ignition switch position by push-button ignition switch (push switch) and vehicle condition.
  • BCM checks the ignition switch position internally.
Refer to COMPONENT LOCATION for detailed installation location.
5. Stop lamp switch Stop lamp switch detects that brake pedal is depressed, and transmits the signal to BCM.
Refer to STOP LAMP SWITCH (without ICC) or STOP LAMP SWITCH (with ICC).
6. Push-button ignition switch Refer to PUSH-BUTTON IGNITION SWITCHΒ .
7. Accessory relay-2
  • Accessory relay-2 is controlled by BCM.
  • Accessory relay-2 supplies accessory power supply or ignition ON signal to each ECU when ignition is turned ON.
  • BCM compares status of accessory relay-2 control signal, and ignition position judged by BCM.
8. Ignition relay-2 (in fuse block)
  • Ignition relay-2 is controlled by BCM.
  • Ignition relay-2 supplies ignition ON power supply or ignition ON signal to each ECU and system when ignition is turned ON.
  • BCM compares status of ignition relay-2 control signal and ignition position judged by BCM.
  • BCM monitors ignition relay-2 operating status by ignition relay-2 feedback signal.
9. Front blower motor relay (in fuse block)
  • Front blower motor relay is controlled by BCM.
  • Front blower motor supplies ignition ON power supply or ignition ON signal to air conditioning system when ignition is turned ON.
  • BCM compares status of front blower motor relay control signal and ignition position judged by BCM.
10. Accessory relay-1 (in fuse block)
  • Accessory relay-1 is controlled by BCM.
  • Accessory relay-1 supplies accessory power supply or ignition ON signal to each ECU when ignition is turned ON.
  • BCM compares status of accessory relay-1 control signal, and ignition position judged by BCM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.