2017 Nissan-Datsun Maxima SLFACTORY OEM SERVICE PROCEDURE

Work Procedure

  1. STEP 1

    1. Turn ignition switch ON.
    2. Open the window not less than halfway.
    3. Pull up on the power window switch to close the window completely. Continue to hold the power window switch up for 3 or more seconds.
    4. Check that AUTO-UP function operates normally.

    GO TO STEP 2Β  .

  2. STEP 2

    Check anti-pinch function. Refer to WORK PROCEDUREΒ .

    Inspection End.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.