WARNING: This page is about a different car, the 2016 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.

SAVING VEHICLE SPECIFICATION

CONSULT

Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

NOTE:
If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

GO TO STEP 2 .

REPLACE BCM

Replace BCM. Refer to REMOVAL AND INSTALLATION .

GO TO STEP 3 .

WRITING VEHICLE SPECIFICATION

CONSULT
1. Enter "Re/Programming, Configuration".
2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to WORK PROCEDURE .
3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to WORK PROCEDURE .
GO TO STEP 4 .

REGISTER INTELLIGENT KEYS

For initialization and registration of Intelligent Keys, refer to CONSULT immobilizer mode and follow the on-screen instructions.

WORK END

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Diagnostic Test

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?