The ignition switch position can be changed by the following operations.

NOTE:

When an Intelligent Key is within the detection area of inside key antenna or when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
When starting the engine, the BCM monitors under the engine start conditions,
CVT models
- Brake pedal operation condition
- Selector lever position
- Vehicle speed
M/T models
- Clutch pedal operation condition
- Vehicle speed

VEHICLE SPEED: LESS THAN 4 KM/H (2.5 MPH)

Power supply position	Condition			Push-button ignition switch operation frequency
	CVT models		M/T models
	Selector lever	Brake pedal operation condition	Clutch pedal operation condition
OFF → ACC	-	Not depressed	Not depressed	1
OFF → ACC → ON	-	Not depressed	Not depressed	2
OFF → ACC → ON → OFF	-	Not depressed	Not depressed	3
OFF → START ACC → START ON → START	P or N position	Depressed	Depressed	1
Engine is running → OFF	-	-	-	1

VEHICLE SPEED: 4 KM/H (2.5 MPH) OR MORE

Power supply position	Condition			Push-button ignition switch operation frequency
	CVT models		M/T models
	Selector lever	Brake pedal operation condition	Clutch pedal operation condition
Engine is running → ACC	-	-	-	Emergency stop operation
Engine stall return operation while driving	N position	Not depressed	Depressed	1

Emergency stop operation

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Ignition Switch Position Change Table By Push-Button Ignition Switch Operation