Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Nissan-Datsun Sentra SLFACTORY OEM SERVICE PROCEDURE
Input/Output Signal Chart
WARNING: This page is about a different car, the 2017 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
| Sensor | Input Signal to ECM | ECM function | Actuator | |
|---|---|---|---|---|
| Crankshaft position sensor (POS) | Engine speed* | Β Air conditioner cut control |
Β IPDM E/R β Air conditioner relay β Compressor |
|
| Camshaft position sensor (PHASE) | ||||
| Engine coolant temperature sensor | Engine coolant temperature | |||
| Accelerator pedal position sensor | Accelerator pedal position | |||
| Battery | Battery voltage* | |||
| Refrigerant pressure sensor | Refrigerant pressure | |||
| EPS control unit | CAN communication | EPS operation signal | ||
| Combination meter | CAN communication | Vehicle speed signal | ||
| BCM | CAN communication |
|
||
* : ECM determines the start signal status by the signals of engine speed and battery voltage.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
