Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Nissan-Datsun Sentra FE+SFACTORY OEM SERVICE PROCEDURE
Work Procedure
WARNING: This page is about a different car, the 2017 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM ECM RECOMMUNICATING FUNCTION
- Install ECM.
- Contact backside of the registered Intelligent Key* to push-button ignition switch while brake pedal is depressed, then turn ignition switch ON.
*: To perform this step, use the key that is used before performing ECM replacement.
- Maintain ignition switch in the ON position for at least 5 seconds.
- Turn ignition switch OFF.
- Check that the engine starts.
GO TO STEP 2 .
- PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
Perform additional service when replacing ECM. Refer to WORK PROCEDURE (MRA8DE) or WORK PROCEDURE (MR16DDT).
Inspection End
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.