Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Work Procedure
- WRITING MODE SELECTION
CONSULT Configuration
Select "Re/programming, Configuration" of air bag.
When writing saved data
GO TO STEP 2 .
When writing manually
GO TO STEP 3 .
- PERFORM "AFTER REPLACE ECU" OF "READ / WRITE CONFIGURATION"
CONSULT Configuration
Perform "After Replace ECU" of "Read / Write Configuration".
GO TO STEP 4 .
- PERFORM "MANUAL CONFIGURATION"
CONSULT Configuration
- Select "Manual Configuration".
- Touch "Next".
- Select the "Type ID" searched by using FAST (service parts catalogue) to write the "Type ID" into the air bag diagnosis sensor unit.
- Touch "OK".
- Check that the configuration has been successfully written and touch "End".
GO TO STEP 4 .
- CHECK ALL ECU SELF DIAGNOSTIC RESULTS
- Erase all ECU "Self Diagnostic Result" using CONSULT.
- Turn the ignition switch OFF.
- Turn the ignition switch ON.
- Check that all ECU "Self Diagnostic Result" have no DTC.
Work End.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
