Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Nissan-Datsun Maxima SLFACTORY OEM SERVICE PROCEDURE
Engine Room
| No. | Component | Function |
|---|---|---|
| IPDM E/R |
|
|
| Mass air flow sensor (with intake air temperature sensor) | MASS AIR FLOW SENSOR (WITH INTAKE AIR TEMPERATURE SENSOR) | |
| Electric throttle control actuator | ELECTRIC THROTTLE CONTROL ACTUATOR | |
| Power valve actuator 2 | POWER VALVE ACTUATOR 1 AND 2 | |
| EVAP canister purge volume control solenoid valve | EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE | |
| VIAS control solenoid valve 2 | VIAS CONTROL SOLENOID VALVE 1 AND 2 | |
| VIAS control solenoid valve 1 | VIAS CONTROL SOLENOID VALVE 1 AND 2 | |
| ABS actuator and electric unit (control unit) | Mainly transmits the following signal to ECM via CAN communication.
Refer to COMPONENT PARTS LOCATION (without ICC), COMPONENT PARTS LOCATION (with ICC) for detailed installation location. |
|
| Power steering oil pump assembly (with power steering control module) | Mainly transmits the following signal to ECM via CAN communication.
Refer to COMPONENT PARTS LOCATION for detailed installation location. |
|
| Electronic controlled engine mount control solenoid valve | ELECTRONIC CONTROLLED ENGINE MOUNT | |
| Power valve actuator 1 | POWER VALVE ACTUATOR 1 AND 2 | |
| Cooling fan motor-2 | COOLING FAN MOTOR | |
| Cooling fan motor-1 | COOLING FAN MOTOR | |
| TCM | Mainly transmits the following signal to ECM via CAN communication.
Refer to COMPONENT PARTS LOCATION for detailed installation location. |
|
| ECM | ECM | |
| Refrigerant pressure sensor | REFRIGERANT PRESSURE SENSOR Refer to COMPONENT PARTS LOCATION for detailed installation location. |
|
| Battery current sensor (with battery temperature sensor) | BATTERY CURRENT SENSOR (WITH BATTERY TEMPERATURE SENSOR) | |
| Cooling fan relay-2 | - | |
| Cooling fan relay-3 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
