2016 Nissan-Datsun Maxima SLFACTORY OEM SERVICE PROCEDURE

Component Parts Location: Body

Fig 1: Engine Control System Components Location (Body)
GNSALBIA1330ZZ-330Courtesy of NISSAN NORTH AMERICA, INC.
WZ-A Center stack WZ-B Steering column area WZ-C Pedal periphery
WZ-D Inside fuel tank WZ-E Rear of fuel tank area    
No. Component Function
WHITE-1 AC auto amp Mainly transmits the following signal to ECM via CAN communication.
  • A/C ON signal
  • Blower fan ON signal

Refer to COMPONENT PARTS LOCATION for detailed installation location.
WHITE-2 Combination meter Mainly transmits the following signal to ECM via CAN communication.
  • Vehicle speed signal
  • Fuel lever sensor signal
  • Fuel filler cap warning reset signal

Mainly receives the following signal from ECM via CAN communication.
  • Malfunction indicator lamp signal
  • Engine oil pressure warning signal
  • Fuel filler cap warning display signal
  • ASCD status signal

Refer to COMPONENT PARTS LOCATION for detailed installation location.
WHITE-3 ASCD steering switch ASCD STEERING SWITCH 
WHITE-4 Stop lamp switch STOP LAMP SWITCH & BRAKE PEDAL POSITION SWITCH 
WHITE-5 Brake pedal position switch STOP LAMP SWITCH & BRAKE PEDAL POSITION SWITCH 
WHITE-6 Accelerator pedal position sensor ACCELERATOR PEDAL POSITION SENSOR 
WHITE-7 Fuel level sensor unit and fuel pump (with fuel tank temperature sensor) FUEL LEVEL SENSOR UNIT AND FUEL PUMP (WITH FUEL TANK TEMPERATURE SENSOR) 
Refer to EXPLODED VIEW for detailed installation location.
WHITE-8 Fuel tank temperature sensor
WHITE-9 EVAP control system pressure sensor EVAP CONTROL SYSTEM PRESSURE SENSOR 
WHITE-10 EVAP canister vent control valve EVAP CANISTER VENT CONTROL VALVE 
WHITE-11 EVAP canister EVAP CANISTER 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.