2016 Nissan-Datsun Maxima SLFACTORY OEM SERVICE PROCEDURE

Component Parts Location

Fig 1: Drive Mode Selector Component Parts Location
GNSDB124144Courtesy of NISSAN NORTH AMERICA, INC.
WZ-A Center console finisher        
No. Component Function
WHITE-1 Combination meter The combination meter receives the drive mode indicator signal via CAN communications from the TCM.
Refer to COMPONENT PARTS LOCATION for detailed installation location.
WHITE-2 TCM
  • The TCM receives the drive mode selector signal via CAN communications from the A/C auto amp.
  • The TCM transmits the drive mode indicator signal via CAN communications to the combination meter.
Refer to COMPONENT PARTS LOCATION for detailed installation location.
WHITE-3 ECM The ECM receives the drive mode signal via CAN communications from the TCM.
Refer to COMPONENT PARTS LOCATION for detailed installation location.
WHITE-4 A/C auto amp. The combination meter transmits the drive mode selector signal via CAN communications to the TCM.
WHITE-5 Drive mode selector Refer to DRIVE MODE SELECTOR .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.