Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Supply Position Change Table By Push-Button Ignition Switch Operation
The power supply position changing operation can be performed with the following operations.
- When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
- When starting the engine, the BCM monitors under the engine start conditions:
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
Vehicle Speed: Less Than 4 Km/H (2.5 MPH)
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency |
||
|---|---|---|---|---|
| With CVT | With M/T | |||
| Selector lever position | Brake pedal condition | Clutch pedal condition | ||
| OFF → ACC | - | Released | Released | 1 |
| OFF → ACC → ON | - | Released | Released | 2 |
| OFF → ACC → ON → OFF | - | Released | Released | 3 |
| OFF → START ACC → START ON → START |
P (Park) or N (Neutral) | Depressed | Depressed | 1 |
| Engine is running → OFF | - | - | - | 1 |
Vehicle Speed: 4 Km/H (2.5 MPH) Or More
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency |
||
|---|---|---|---|---|
| With CVT | With M/T | |||
| Selector lever position | Brake pedal condition | Clutch pedal condition | ||
| Engine is running → ACC | - | - | - | Emergency stop operation |
| Engine stall return operation while driving | N (Neutral) | Released | Depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.