Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Detailed Flow
- INTERVIEW FROM THE CUSTOMERÂ
Clarify customer complaints before inspection. First of all, perform an interview utilizing "DIAGNOSTIC WORK SHEETÂ " and reproduce symptoms as well as fully understand it. Ask customer about his/her complaints carefully. Check symptoms by driving vehicle with customer, if necessary.
CAUTION: Customers are not professional. Never guess easily like "maybe the customer means that...," or "maybe the customer mentions this symptom".: GO TO 2.
- CHECK SYMPTOMÂ
Reproduce the symptom that is indicated by the customer, based on the information from the customer obtained by interview. Also check that the symptom is not caused by protection function. Refer to "PROTECTION FUNCTIONÂ ".
CAUTION: When the symptom is caused by normal operation, fully inspect each portion and obtain the understanding of customer that the symptom is not caused by a malfunction.: GO TO 3.
- PERFORM SELF-DIAGNOSISÂ
With CONSULTÂ
Perform self-diagnosis.
Is any DTC detected?Â
YES: Record or print DTC and freeze frame data (FFD). GO TO 4.
NO: GO TO Â 6.
- RECHECK SYMPTOMÂ
With CONSULTÂ
- Erase self-diagnostic results.
- Perform DTC confirmation procedures for the malfunctioning system.NOTE: If some DTCs are detected at the same time, determine the order for performing the diagnosis based on "DTC INSPECTION PRIORITY CHARTÂ ".
Is any DTC detected?Â
YES: GO TO 5.
NO: Check harness and connectors based on the information obtained by interview. Refer to "INTERMITTENT INCIDENT ".
- REPAIR OR REPLACE MALFUNCTIONING PARTSÂ
- Repair or replace malfunctioning parts.
- Reconnect part or connector after repairing or replacing.
- When DTC is detected, erase self-diagnostic results for "EPS".
: GO TO Â 7.
- IDENTIFY MALFUNCTIONING SYSTEM BY SYMPTOM DIAGNOSISÂ
Estimate malfunctioning system based on symptom diagnosis and perform inspection.
Can the malfunctioning system be identified?Â
YES: GO TO 7.
NO: Check harness and connectors based on the information obtained by interview. Refer to "INTERMITTENT INCIDENT ".
- FINAL CHECKÂ
With CONSULTÂ
- Check the reference value for EPS control unit.
- Recheck the symptom and check that symptom is not reproduced on the same conditions.
Is the symptom reproduced?Â
YES: GO TO Â 3.
NO: Inspection End.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
