Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Nissan-Datsun Sentra SLFACTORY OEM SERVICE PROCEDURE
Input/Output Signal Chart
| Sensor | Input Signal to ECM | ECM function | Actuator | |||
|---|---|---|---|---|---|---|
| Crankshaft position sensor (POS) | Engine speed(1) Piston position |
Air conditioner cut control | IPDM E/R β Air conditioner relay β Compressor |
|||
| Camshaft position sensor (PHASE) | ||||||
| Engine coolant temperature sensor | Engine coolant temperature | |||||
| Accelerator pedal position sensor | Accelerator pedal position | |||||
| Battery | Battery voltage(1) | |||||
| Refrigerant pressure sensor | Refrigerant pressure | |||||
| EPS control unit | CAN communication | EPS operation signal | ||||
| Combination meter | CAN communication | Vehicle speed signal | ||||
| A/C auto amp. | CAN communication |
|
||||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
