2014 Nissan-Datsun Sentra SLFACTORY OEM SERVICE PROCEDURE

Ignition Switch Position Change Table By Push-Button Ignition Switch Operation

The ignition switch position can be changed by the following operations.

NOTE:
  • When an Intelligent Key is within the detection area of inside key antenna or when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
  • When starting the engine, the BCM monitors under the engine start conditions,

    CVT models 

    • Brake pedal operation condition
    • Selector lever position
    • Vehicle speed

    M/T models 

    • Clutch pedal operation condition
    • Vehicle speed
VEHICLE SPEED

Power supply position Condition Push-button ignition switch operation frequency
CVT models M/T models
Selector lever Brake pedal operation condition Clutch pedal operation condition
OFF → ACC - Not depressed Not depressed 1
OFF → ACC → ON - Not depressed Not depressed 2
OFF → ACC → ON → OFF - Not depressed Not depressed 3
OFF → START
ACC → START
ON → START		 P or N position Depressed Depressed 1
Engine is running → OFF - - - 1
VEHICLE SPEED

Power supply position Condition Push-button ignition switch operation frequency
CVT models M/T models
Selector lever Brake pedal operation condition Clutch pedal operation condition
Engine is running → ACC - - - Emergency stop operation
Engine stall return operation while driving N position Not depressed Depressed 1

Emergency stop operation

  • Press and hold the push-button ignition switch for 2 seconds or more.
  • Press the push-button ignition switch 3 times or more within 1.5 seconds.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.