2013 Nissan-Datsun NV3500 HD S, Van CargoFACTORY OEM SERVICE PROCEDURE

Fuel Pressure Release

  1. FUEL PRESSURE RELEASE 

    With CONSULT

    1. Turn ignition switch ON.
    2. Perform "FUEL PRESSURE RELEASE " in "WORK SUPPORT" mode of "ENGINE" using CONSULT.
    3. Start engine.
    4. After engine stalls, crank it 2 or 3 times to release all fuel pressure.
    5. Turn ignition switch OFF.

    Without CONSULT

    1. Remove fuel pump fuse (1) located in IPDM E/R (2). Refer to "REMOVAL AND INSTALLATION ".
    2. Start engine.
    3. After engine stalls, crank it 2 or 3 times to release all fuel pressure.
    4. Turn ignition switch OFF.
    5. Reinstall fuel pump fuse after servicing fuel system.

      : END

      Fig 1: Identifying Fuel Pump Fuse And IPDM E/R
      G09017045Courtesy of NISSAN NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.