2013 Nissan-Datsun Altima BaseFACTORY OEM SERVICE PROCEDURE

Component Description

WARNING: This page is about a different car, the 2013 Nissan Cube. However, it is still accessible from the selected car via links, so may be relevant.
BCM Reference
IPDM E/R POWER CONTROL SYSTEM
Ignition relay (Built-in IPDM E/R) B2616 IGNITION RELAY CIRCUIT 
Ignition relay B2616 IGNITION RELAY CIRCUIT 
Accessory relay B2614 ACC RELAY CIRCUIT 
Blower relay B2615 BLOWER RELAY CIRCUIT 
Stop lamp switch B2555 STOP LAMP
Transmission range switch B2604 SHIFT POSITION
Push-button ignition switch B261A PUSH-BUTTON IGNITION SWITCH 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.