2012 Nissan-Datsun Sentra SLFACTORY OEM SERVICE PROCEDURE

Ignition Timing

Any of following two methods may be used.

Method A

  1. Attach timing light to loop wire (1) as shown in the figure.
    Fig 1: Identifying Loop Wire
    G08186694Courtesy of NISSAN NORTH AMERICA, INC.
  2. Check ignition timing.
Fig 2: Checking Ignition Timing Using Timing Indicator
G08186695Courtesy of NISSAN NORTH AMERICA, INC.

Method B

  1. Remove No. 4 ignition coil (1).
    Fig 3: Identifying No. 4 Ignition Coil
    G08186696Courtesy of NISSAN NORTH AMERICA, INC.
  2. Connect No. 4 ignition coil (1) and No. 4 spark plug with suitable high-tension wire (A) as shown in the figure, and attach timing light clamp (B) to this wire.
    Fig 4: Identifying Ignition Coil, High-Tension Wire And Timing Light Clamp
    G08186697Courtesy of NISSAN NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.