SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012SENTRA SE-RREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSMISSION (CVT)SERVICE INFORMATIONDTC INDEXDTC NO. INDEX
2012 Nissan-Datsun Sentra SE-R

DTC No. Index

2012 Nissan-Datsun Sentra SE-RSECTION DTC No. Index
NOTE: If DTC "U1000" is displayed with other DTCs, first perform the trouble diagnosis for DTC "U1000". Refer to U1000 CAN COMM CIRCUIT .
DTC Items (CONSULT screen terms) Reference
MIL(1), "ENGINE" with CONSULT or GST CONSULT only "TRANSMISSION"
- P0703  BRAKE SWITCH B  
P0705 P0705  T/M RANGE SWITCH A  
P0710 P0710  FLUID TEMP SENSOR A  
P0715 P0715  INPUT SPEED SENSOR A  
P0720 P0720  OUTPUT SPEED SENSOR  
- P0725  ENGINE SPEED  
- P0730  INCORRECT GR RATIO  
P0740 P0740  TORQUE CONVERTER  
P0744 P0744  TORQUE CONVERTER  
P0745 P0745  L/PRESS SOL/CIRC  
P0746 P0746  PC SOLENOID A  
P0776 P0776  PC SOLENOID B  
P0778 P0778  PC SOLENOID B  
- P0826  UP/DOWN SHIFT SWITCH  
P0840 P0840  FLUID PRESS SEN/SW A  
- P0841  FLUID PRESS SEN/SW A  
- P0868  FLUID PRESS LOW  
- P1701  TCM  
- P1705  TP SENSOR  
- P1722  VEHICLE SPEED(2)  
- P1723  SPEED SENSOR  
- P1726  THROTTLE CONTROL SIG  
P1740 P1740  SLCT SOLENOID  
- P1745  LINE PRESS CONTROL  
P1777 P1777  STEP MOTOR  
P1778 P1778  STEP MOTOR  
U1000 U1000  CAN COMM CIRCUIT  
U1010 U1010  CONTROL UNIT (CAN)  
(1) Refer to "INTRODUCTION ".
(2) Models without ABS does not indicate.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.