2012 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Alphabetical Index

NOTE: If DTC "U1000" is displayed with other DTCs, first perform the trouble diagnosis for DTC "U1000". Refer to U1000 CAN COMM CIRCUIT .
Items (CONSULT screen terms) DTC Reference
MIL(2), "ENGINE" with CONSULT or GST CONSULT only "TRANSMISSION"
BRAKE SWITCH B - P0703   
CAN COMM CIRCUIT U1000 U1000   
CONTROL UNIT (CAN) U1010 U1010   
ENGINE SPEED - P0725   
FLUID PRESS LOW - P0868   
FLUID PRESS SEN/SW A P0840 P0840   
FLUID PRESS SEN/SW A - P0841   
FLUID TEMP SENSOR A P0710 P0710   
INCORRECT GR RATIO - P0730   
INPUT SPEED SENSOR A P0715 P0715   
LINE PRESS CONTROL - P1745   
OUTPUT SPEED SENSOR P0720 P0720   
PL SOLENOID A P0745 P0745   
PC SOLENOID A P0746 P0746   
PC SOLENOID B P0778 P0778   
PC SOLENOID B P0776 P0776   
SLCT SOLENOID P1740 P1740   
SPEED SENSOR - P1723   
STEP MOTOR P1777 P1777   
STEP MOTOR P1778 P1778   
TCM - P1701   
THROTTLE CONTROL SIG - P1726   
T/M RANGE SWITCH A P0705 P0705   
TORQUE CONVERTER P0744 P0744   
TORQUE CONVERTER P0740 P0740   
TP SENSOR - P1705   
UP/DOWN SHIFT SWITCH - P0826   
VEHICLE SPEED(3) - P1722   
(1) These numbers are prescribed by SAE J2012.
(2) Refer to "INTRODUCTION ".
(3) Models without ABS does not indicate.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.