Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Saved Data List Reprogramming With Consult III Plus (NTB12-074)
WARNING: This page is about the Sentra Base, Automatic CVT Trans, which is a different variant/trim than selected.
Publication date: 2012-09-12Reference number: NTB12-074
SAVED DATA LIST REPROGRAMMING WITH CONSULT III PLUS
TECHNICAL SERVICE BULLETIN
Reference Number(s): NTB12-074, Date of Issue:
September 12, 2012
| CLASSIFICATION: | EC12-021 |
| APPLIED VEHICLES: | All |
SERVICE INFORMATION
- When performing a "Reprogramming" operation with C-III plus, the screen in Figure 1 may display.
- This screen displays "Saved Data" from previous C-III plus operations.
- During the initial "Reprogramming Confirmation" set-up, if you get this screen:
- Select Delete , then
- Select Other Operation , then
- Continue with the reprogramming procedure.
NOTE:
If reprogramming does not complete, this screen can display for reprogramming recovery. Do not select Delete if this screen displays during reprogram recovery.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.