Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Throttle Position Sensor
- Reconnect all harness connectors disconnected.
- Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
- Turn ignition switch ON.
- Set selector lever to D position (CVT) or 1st position (M/T).
- Check voltage between ECM terminals 37 (TP sensor 1 signal), 38 (TP sensor 2 signal) and ground under the following conditions.
Terminal Accelerator pedal Voltage 37 (Throttle position sensor 1) Fully released More than 0.36 V Fully depressed Less than 4.75 V 38 (Throttle position sensor 2) Fully released Less than 4.75 V Fully depressed More than 0.36 V - If NG, replace electric throttle control actuator. Refer to , "REMOVAL AND INSTALLATION ".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
