Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Glass, Window System & Mirrors
- Service Information
- Precautions
- Preparation
- Squeak And Rattle Trouble Diagnoses
- Windshield Glass
- Rear Window Glass And Molding
- Power Window System
- Component Parts and Harness Connector Location
- System Description
- CAN Communication System Description
- Schematic
- Wiring Diagram - WINDOW -
- Main Power Window and Door Lock/Unlock Switch Harness Connector Terminal Layout
- Terminal and Reference Value for Main Power Window and Door Lock/Unlock Switch
- Terminal and Reference Value for BCM
- Work Flow
- CONSULT Function (BCM)
- Trouble Diagnosis Symptom Chart
- BCM Power Supply and Ground Circuit Inspection
- Main Power Window and Door Lock/Unlock Switch Power Supply and Ground Circuit Inspection
- Power Window and Door Lock/Unlock Switch RH Power Supply Circuit Inspection
- Front Power Window LH Circuit Inspection
- Front Power Window RH Circuit Inspection (Power Window and Door Lock/Unlock Switch RH Operation)
- Front Power Window RH Circuit Inspection (Main Power Window and Door Lock/Unlock Switch Operation)
- Door Switch Check
- Rear Power Window LH Circuit Inspection (Rear Power Window Switch LH Operation)
- Rear Power Window LH Circuit Inspection (Main Power Window and Door Lock/Unlock Switch Operation)
- Rear Power Window RH Circuit Inspection (Rear Power Window Switch RH Operation)
- Rear Power Window RH Circuit Inspection (Main Power Window and Door Lock/Unlock Switch Operation)
- Encoder and Limit Switch Check
- Front Door Glass And Regulator
- Rear Door Glass And Regulator
- Rear Window Defogger
- Component Parts and Harness Connector Location
- System Description
- CAN Communication System Description
- Schematic
- Wiring Diagram - DEF -
- Terminal and Reference Value for BCM
- Terminal and Reference Value for IPDM E/R
- Work Flow
- CONSULT Function (BCM)
- Trouble Diagnosis Symptom Chart
- BCM Power Supply and Ground Circuit Inspection
- Rear Window Defogger Switch Circuit Inspection
- Rear Window Defogger Circuit Inspection
- Door Mirror Defogger Circuit Inspection
- Filament Check
- Filament Repair
- Door Mirror
- Inside Mirror
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.