2012 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

CAN Communication Inspection Using CONSULT (Self-Diagnosis)

  1. SELF-DIAGNOSTIC RESULT CHECK
    1. Connect CONSULT and select "BCM" on "SELECT SYSTEM" screen.
    2. Select "BCM" on "SELECT TEST ITEM" screen, and select "SELF-DIAG RESULTS".
    3. Check display content in self-diagnostic results.
      CONSULT display code Diagnosis item
      U1000 INITIAL DIAG
      TRANSMIT DIAG
      ECM
      IPDM E/R
      METER/M&A
      I-KEY

      Contents displayed 

      No malfunction >> Inspection End.

      Malfunction in CAN communication system >> After printing the monitor items. Refer to , "CONDITION OF ERROR DETECTION ".

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.