SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012SENTRA SE-RREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM - DTCS P0603 TO P2A03 (QR25DE)DTC P2135: TP SENSORCONSULT REFERENCE VALUE IN DATA MONITOR MODE
2012 Nissan-Datsun Sentra SE-R

CONSULT Reference Value in Data Monitor Mode

2012 Nissan-Datsun Sentra SE-RSECTION CONSULT Reference Value in Data Monitor Mode

Specification data are reference values.

SPECIFICATION DATA

Monitor item Condition Specification
TP SEN 1-B1
TP SEN 2-B2(1)
  • Ignition switch: ON (Engine stopped)
  • Selector lever: D (CVT), 1st (M/T)
 Accelerator pedal: Fully released More than 0.36 V
Accelerator pedal: Fully depressed Less than 4.75 V
(1) Throttle position sensor 2 signal is converted by ECM internally. Thus, it differs from ECM terminal voltage signal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.