2012 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Keyfob Battery and Function Check

NOTE: The Signal Tech II tool (J-50190) can be used to test the remote keyless entry keyfob relative signal strength. Refer to the Signal Tech II User Guide for additional information.
  1. CHECK KEYFOB BATTERY
    1. Remove keyfob battery. Refer to , "KEYFOB BATTERY REPLACEMENTΒ ".
    2. Measure voltage between battery positive and negative terminals, (+) and (-).

      Voltage: 2.5 - 3.0VΒ 

      Fig 1: Checking Keyfob Battery
      G04877105Courtesy of NISSAN NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.