2012 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

CONSULT Function (INTELLIGENT KEY): Notes

CONSULT can display each diagnostic item using the diagnostic test modes as shown below.

Test item, Diagnosis mode Description
WORK SUPPORT Changes settings for each function.
SELF DIAGNOSTIC RESULT Intelligent Key unit performs CAN communication diagnosis.
DATA MONITOR Displays Intelligent Key unit input data in real time.
CAN DIAG SUPPORT MONITOR The results of transmit/receive diagnosis of CAN Communication can be read.
ACTIVE TEST Operation of electrical loads can be checked by sending driving signal to then.
ECU IDENTIFICATION Displays Intelligent Key unit part No.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.