Transaxle Assembly: Remove & Replace

2012 Nissan-Datsun Sentra SE-RSECTION Remove & Replace
WARNING: This page is about the Sentra Base, Automatic CVT Trans, which is a different variant/trim than selected.
Applies ToNoteStandard HoursWarranty HoursSkill Level
2.0L EngIncludes: Programming. DOES NOT include wheel alignment.9.06.5C
Combination Procedure: CONVERTER: Drain & Test:
0.2C
Combination Procedure: CRANKSHAFT MAIN OIL SEAL: Remove & Replace:
Rear0.4B
Combination Procedure: FLYWHEEL: Remove & Replace:
0.2C
Combination Procedure: TORQUE CONVERTER: Remove & Replace:
0.1C
Combination Procedure: TRANSAXLE OIL COOLER: Clean:
0.5C
Combination Procedure: TRANSMISSION OIL COOLER & LINES: Flush:
Includes: Confirm Fluid temperature for level check.0.8C
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.