2012 Nissan-Datsun Cube SLFACTORY OEM SERVICE PROCEDURE

Work Procedure (Group A)

Fig 1: Identifying Permanent DTC Status, DTC, MIL And Driving Pattern
G08128702Courtesy of NISSAN NORTH AMERICA, INC.
  1. CHECK DTC

    Check DTC.

    Is any DTC detected? 

    YES-1 >> With CONSULT: Repair malfunction(s) and erase DTC. Refer to "CONSULT FUNCTION ".

    YES-2 >> Without CONSULT: Repair malfunction(s) and erase DTC. Refer to "ON BOARD DIAGNOSIS FUNCTION ".

    NO >> GO TO 2.

  2. CHECK PERMANENT DTC

    With CONSULT

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select "PERMANENT DTC STATUS" mode with CONSULT.

    With GST

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select Service $0A with GST.

      Is any permanent DTC detected? 

      YES >> GO TO 3.

      NO >> END

  3. PERFORM DTC CONFIRMATION PROCEDURE

    Perform "DTC CONFIRMATION PROCEDURE" for DTCs which are the same as permanent DTCs stored in ECM. Refer to "DTC INDEX ".

    >> GO TO 4.

  4. CHECK PERMANENT DTC

    With CONSULT

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select "PERMANENT DTC STATUS" mode with CONSULT.

    With GST

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Select Service $0A with GST.

      Is any permanent DTC detected? 

      YES >> GO TO  1.

      NO >> END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.