Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Nissan-Datsun Cube BaseFACTORY OEM SERVICE PROCEDURE
Component Function Check
- ASCD INDICATOR FUNCTION
Check ASCD indicator under the following conditions.
ASCD indicator Condition Specification CRUISE LAMP - Ignition switch: ON
- MAIN switch: Pressed at the 1st time → at the 2nd time
ON → OFF SET LAMP - MAIN switch: ON
- When vehicle speed: Between 40 km/h (25 MPH) and 190 km/h (118 MPH) (For the Middle East), 40 km/h (25 MPH) and 160 km/h (100 MPH) (Except for the Middle East)
- ASCD: Operating
ON - ASCD: Not operating
OFF Is the inspection result normal?
YES >> INSPECTION END
NO >> Go to "Diagnosis Procedure ".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.