2012 Nissan-Datsun Altima BaseFACTORY OEM SERVICE PROCEDURE

Component Inspection

  1. CHECK PUSH-BUTTON IGNITION SWITCH

    Check push-button ignition switch.

    Terminal Push-button ignition switch position Continuity
    Push-button ignition switch
    8 5 LOCK Yes
    6 ACC
    7 ON
    Fig 1: Checking Push-Button Ignition Switch
    G05047408Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?Β 

    YES: Inspection End.

    NO: Replace push-button ignition switch. Refer to "REMOVAL AND INSTALLATIONΒ ".

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.