2011 Nissan-Datsun Sentra SLFACTORY OEM SERVICE PROCEDURE

Commercial Service Tool

COMMERCIAL SERVICE TOOLS DESCRIPTION CHART

Tool number (Kent-Moore No.) Tool name Description
Leak detector
i.e.: (J-41416)
G07137795Courtesy of NISSAN MOTOR CO., U.S.A.
Locating the EVAP leak
EVAP service port adapter
i.e.: (J-41413-OBD)
G07137796Courtesy of NISSAN MOTOR CO., U.S.A.
Applying positive pressure through EVAP service port
Fuel filler cap adapter
i.e.: (MLR-8382)
G07137797Courtesy of NISSAN MOTOR CO., U.S.A.
Checking fuel tank vacuum relief valve opening pressure
Socket wrench
G07137798Courtesy of NISSAN MOTOR CO., U.S.A.
Removing and installing engine coolant temperature sensor
Oxygen sensor thread cleaner
i.e.: (J-43897-18)
(J-43897-12)
G07137799Courtesy of NISSAN MOTOR CO., U.S.A.
Reconditioning the exhaust system threads before installing a new oxygen sensor. Use with antiseize lubricant shown below.
  1. 18 mm diameter with pitch 1.5 mm for Zirconia Oxygen Sensor 
  2. 12 mm diameter with pitch 1.25 mm for Titania Oxygen Sensor 
Anti-seize lubricant i.e.: (Permatex™ 133AR or equivalent meeting MIL specification MIL-A-907)
G07137800Courtesy of NISSAN MOTOR CO., U.S.A.
Lubricating oxygen sensor thread cleaning tool when reconditioning exhaust system threads.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.