Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Nissan-Datsun Cube BaseFACTORY OEM SERVICE PROCEDURE
Without Intelligent Key System
SECURITY CONTROL SYSTEM DIAGNOSTIC TROUBLE CODES (DTC) LIST WITHOUT INTELLIGENT KEY SYSTEM
| DTC | Description |
|---|---|
| DTC P1610 | LOCK MODE |
| DTC P1611 | ID DISCORD, IMMU-ECM |
| DTC P1612 | CHAIN OF ECM-IMMU |
| DTC P1614 | CHAIN OF IMMU-KEY |
| DTC P1615 | DIFFERENCE OF KEY |
| DTC B2190 | NATS ANTENNA AMP |
| DTC B2191 | DIFFERENCE OF KEY |
| DTC B2192 | ID DISCORD, IMMU-ECM |
| DTC B2193 | CHAIN OF ECM-IMMU |
| DTC B2195 | ANTI-SCANNING |
| DTC B2196 | DONGLE UNIT |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
