2010 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Alphabetical Index

NOTE: If DTC "U1000" is displayed with other DTCs, first perform the trouble diagnosis for DTC "U1000". Refer to U1000 CAN COMM CIRCUIT .
DTC CHART

Items (CONSULT-III screen terms) DTC(1)
MIL(2), "ENGINE" with CONSULT-III or GST CONSULT-III only "TRANSMISSION"
BRAKE SWITCH B - P0703 
CAN COMM CIRCUIT U1000 U1000 
CONTROL UNIT (CAN) U1010 U1010 
ENGINE SPEED - P0725 
FLUID PRESS LOW - P0868 
FLUID PRESS SEN/SW A P0840  P0840
FLUID PRESS SEN/SW A - P0841 
FLUID TEMP SENSOR A P0710  P0710
INCORRECT GR RATIO - P0730 
INPUT SPEED SENSOR A P0715  P0715
LINE PRESS CONTROL - P1745 
OUTPUT SPEED SENSOR P0720  P0720
PL SOLENOID A P0745  P0745
PC SOLENOID A P0746  P0746
PC SOLENOID B P0778  P0778
PC SOLENOID B P0776  P0776
SLCT SOLENOID P1740  P1740
SPEED SENSOR - P1723 
STEP MOTOR P1777  P1777
STEP MOTOR P1778  P1778
TCM - P1701 
THROTTLE CONTROL SIG - P1726 
T/M RANGE SWITCH A P0705  P0705
TORQUE CONVERTER P0744  P0744
TORQUE CONVERTER P0740  P0740
TP SENSOR - P1705 
UP/DOWN SHIFT SWITCH - P0826 
VEHICLE SPEED(3) - P1722 
(1) These numbers are prescribed by SAE J2012.
(2) Refer to "INTRODUCTION ".
(3) Models without ABS does not indicate.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.